4 hdd в 10 рейде. Добавил ещё один hdd для всяких файлов бекапов. Только вот никак не могу его подключить через arcconf. Диск виден.
Код: Выделить всё
Device #4
Device is a Hard drive
State : Ready
Supported : Yes
Transfer Speed : SATA 1.5 Gb/s
Reported Channel,Device(T:L) : 0,4(4:0)
Reported Location : Enclosure 0, Slot 4
Reported ESD(T:L) : 2,0(0:0)
Vendor : ST2000VX
Model : 000-1CU164
Firmware : CV23
Serial number : W1E747KJ
Size : 1907729 MB
Write Cache : Enabled (write-back)
FRU : None
S.M.A.R.T. : No
S.M.A.R.T. warnings : 0
NCQ status : Disabled
Код: Выделить всё
#arcconf CREATE 1 JBOD 0 4 noprompt
Controllers found: 1
The requested feature is not supported on this controller.
Command aborted.
Пока пробовал только arcconf(OS Freebsd), можно попробовать в биос рейда залезть, но
как бы намекает... Как можно решить проблему?The requested feature is not supported on this controller.