Различные нюансы с Adaptec RAID 5085Z

[ingvarr]

Добрый день.
Свежий сервер, ряд сомнительных проявлений.
Буду признателен пояснениям.


1. При старте в половине случаев пишет: "ZMM Status: Charging / Not Ready". Сервер запитан постоянно.

2. Фирменный демон для стыковки агента с snmp падает.
Версия 7.00.18781.
Debian linux wheezy, amd64.
Всё аналогично тому, что тут: http://hwraid.le-vert.net/ticket/91

3. На ядре linux 2.6.32 запускается нормально. На 3.0.0 требует rootdelay=120.
Из процитированных ниже логов видно, что в ядре 3.0.0 RAID идентифицируется не как scsi0, а как scsi4, а всё, что на 2.6.32 происходит моментально, тут вызывает последовательную задержку на 20, а потом ещё на 10 секунд.

Выдержки из dmesg:
=== 2.6.32 ===
[ 2.118716] SCSI subsystem initialized
[ 2.120451] Adaptec aacraid driver 1.1-7[28000]-ms
...
[ 2.181547] IRQ 50/aacraid: IRQF_DISABLED is not guaranteed on shared IRQs
[ 2.392887] AAC0: kernel 5.2-0[18252] Nov 22 2010
[ 2.392977] AAC0: monitor 5.2-0[18252]
[ 2.393066] AAC0: bios 5.2-0[18252]
[ 2.393147] AAC0: serial 0B41117E881
[ 2.393228] AAC0: Non-DASD support enabled.
[ 2.393311] AAC0: 64bit support enabled.
[ 2.393393] AAC0: 64 Bit DAC enabled
[ 2.406383] scsi0 : aacraid
[ 2.406675] scsi 0:0:0:0: Direct-Access Adaptec main V1.0 PQ: 0 ANSI: 2
[ 2.406893] scsi 0:0:1:0: Direct-Access Adaptec shitpool V1.0 PQ: 0 ANSI: 2
[ 2.415393] scsi 0:1:0:0: Direct-Access HITACHI HUS156045VLS600 A5D0 PQ: 1 ANSI: 6
[ 2.415850] scsi 0:1:1:0: Direct-Access HITACHI HUS156045VLS600 A5D0 PQ: 1 ANSI: 6
[ 2.416270] scsi 0:1:2:0: Direct-Access HITACHI HUS156045VLS600 A5D0 PQ: 1 ANSI: 6
[ 2.416705] scsi 0:1:3:0: Direct-Access HITACHI HUS156045VLS600 A5D0 PQ: 1 ANSI: 6
[ 2.417067] scsi 0:1:4:0: Direct-Access Hitachi HDS723020BLA642 MN6O PQ: 1 ANSI: 5
[ 2.417340] scsi 0:1:5:0: Direct-Access Hitachi HDS723020BLA642 MN6O PQ: 1 ANSI: 5
[ 2.417600] scsi 0:1:6:0: Direct-Access Hitachi HDS723020BLA642 MN6O PQ: 1 ANSI: 5
[ 2.417861] scsi 0:1:7:0: Direct-Access Hitachi HDS723020BLA642 MN6O PQ: 1 ANSI: 5
...
[ 2.504497] scsi 0:3:0:0: Enclosure ADAPTEC Virtual SGPIO 0 0001 PQ: 0 ANSI: 5
...
[ 2.797758] sd 0:0:0:0: [sda] 1757413376 512-byte logical blocks: (899 GB/838 GiB)
[ 2.797829] sd 0:0:1:0: [sdb] Very big device. Trying to use READ CAPACITY(16).
[ 2.797854] sd 0:0:1:0: [sdb] 11702087680 512-byte logical blocks: (5.99 TB/5.44 TiB)
[ 2.797876] sd 0:0:1:0: [sdb] Write Protect is off
[ 2.797878] sd 0:0:1:0: [sdb] Mode Sense: 06 00 10 00
[ 2.797915] sd 0:0:1:0: [sdb] Write cache: disabled, read cache: enabled, supports DPO and FUA
[ 2.798033] sd 0:0:1:0: [sdb] Very big device. Trying to use READ CAPACITY(16).
[ 2.798092] sdb:
[ 2.801593] sd 0:0:0:0: Attached scsi generic sg0 type 0
[ 2.801648] sd 0:0:1:0: Attached scsi generic sg1 type 0
===========

=== 3.0.0 ===
[ 2.423175] SCSI subsystem initialized
...
[ 2.441386] aacraid 0000:84:00.0: PCI INT A -> GSI 50 (level, low) -> IRQ 50
[ 2.447481] aacraid 0000:84:00.0: setting latency timer to 64
[ 2.724377] AAC0: kernel 5.2-0[18252] Nov 22 2010
[ 2.724467] AAC0: monitor 5.2-0[18252]
[ 2.724553] AAC0: bios 5.2-0[18252]
[ 2.724635] AAC0: serial 0B41117E881
[ 2.724716] AAC0: Non-DASD support enabled.
[ 2.724799] AAC0: 64bit support enabled.
[ 2.724881] AAC0: 64 Bit DAC enabled
[ 2.737877] scsi4 : aacraid
[ 2.738175] scsi 4:0:0:0: Direct-Access Adaptec main V1.0 PQ: 0 ANSI: 2
...
[ 2.908420] scsi 4:0:1:0: Direct-Access Adaptec shitpool V1.0 PQ: 0 ANSI: 2
...
[ 5.446242] scsi 4:1:0:0: Direct-Access HITACHI HUS156045VLS600 A5D0 PQ: 1 ANSI: 6
[ 5.446713] scsi 4:1:1:0: Direct-Access HITACHI HUS156045VLS600 A5D0 PQ: 1 ANSI: 6
[ 5.447165] scsi 4:1:2:0: Direct-Access HITACHI HUS156045VLS600 A5D0 PQ: 1 ANSI: 6
[ 5.447624] scsi 4:1:3:0: Direct-Access HITACHI HUS156045VLS600 A5D0 PQ: 1 ANSI: 6
[ 5.448003] scsi 4:1:4:0: Direct-Access Hitachi HDS723020BLA642 MN6O PQ: 1 ANSI: 5
[ 5.448301] scsi 4:1:5:0: Direct-Access Hitachi HDS723020BLA642 MN6O PQ: 1 ANSI: 5
[ 5.448589] scsi 4:1:6:0: Direct-Access Hitachi HDS723020BLA642 MN6O PQ: 1 ANSI: 5
[ 5.448881] scsi 4:1:7:0: Direct-Access Hitachi HDS723020BLA642 MN6O PQ: 1 ANSI: 5
...
[ 25.225907] scsi 4:3:0:0: Enclosure ADAPTEC Virtual SGPIO 0 0001 PQ: 0 ANSI: 5
[ 35.376361] sd 4:0:0:0: [sda] 1757413376 512-byte logical blocks: (899 GB/838 GiB)
[ 35.376385] sd 4:0:1:0: [sdb] Very big device. Trying to use READ CAPACITY(16).
[ 35.376412] sd 4:0:1:0: [sdb] 11702087680 512-byte logical blocks: (5.99 TB/5.44 TiB)
[ 35.376438] sd 4:0:1:0: [sdb] Write Protect is off
[ 35.376441] sd 4:0:1:0: [sdb] Mode Sense: 06 00 10 00
[ 35.376484] sd 4:0:1:0: [sdb] Write cache: disabled, read cache: enabled, supports DPO and FUA
[ 35.376607] sd 4:0:1:0: [sdb] Very big device. Trying to use READ CAPACITY(16).
[ 35.377064] sd 4:0:0:0: [sda] Write Protect is off
[ 35.377151] sd 4:0:0:0: [sda] Mode Sense: 06 00 10 00
[ 35.377182] sd 4:0:0:0: [sda] Write cache: disabled, read cache: enabled, supports DPO and FUA
[ 35.378410] sd 4:0:0:0: Attached scsi generic sg0 type 0
[ 35.378534] sd 4:0:1:0: Attached scsi generic sg1 type 0
==========

[cher]

Напишите на support@trinity.spb.ru с указанием № гарант. талона